A Coldharbour company - serving Henderson, NV

Carrier Furnace Repair in Henderson, NV

AC repairAC repair
Furnace & heatingFurnace & heating
Heat pumpsHeat pumps
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Carrier Furnace Repair in Henderson: What to Know First

We provide independent Carrier furnace repair in Henderson, and most jobs are diagnosed and fixed in a single visit. Typical repairs run $150 – $700 depending on the part, and you’ll have a written price in hand before any tool comes out of the bag. As an independent Carrier service provider, we’re not affiliated with or authorized by the manufacturer, but our technicians are trained to service Carrier equipment, including Trane and Lennox systems.

Call (844) 797-5122

This page is for Henderson homeowners who own a Carrier furnace and want to know what’s likely wrong, what it should cost, and who to call without getting a surprise at the door. Our technicians have up to 23 years of experience. Call (844) 797-5122 and a live person will pick up, day or night.

How Carrier Products Fail – and How We Fix Them

  • Igniter failures on the Comfort and Performance series. Carrier’s silicon nitride hot-surface igniters (the small ceramic element that glows to light the burners) crack after a few Henderson heating seasons of on-off cycling, and the furnace runs but never lights. Most replacements land in our $150 – $280 range, parts and labor included, and we test the full ignition sequence afterward so the part doesn’t fail again in a month.
  • Pressure switch faults on high-efficiency Carrier models. The 58 series condensing furnaces (with the secondary heat exchanger and PVC venting) are prone to pressure switch trips when the condensate drain traps or venting clog. In Henderson’s dry, dusty air, we see this more often than on standard-efficiency units. We clear the drain, check the vent, and confirm the switch reads correctly before closing up.
  • Flame sensor buildup causing short cycling. Carrier flame sensors (the probe that tells the board a flame is actually present) oxidize over time, so the furnace lights, runs a few minutes, and shuts down. This one is common across the Carrier lineup and won’t always throw a code. We clean or replace the sensor and verify steady flame sensing through a full cycle.
  • Gas valve and manifold issues. On older Carrier units, we sometimes find weak gas valves that open slowly or short out the ignition sequence. We trace it with a manometer (a gauge that reads gas pressure) rather than guessing, and replace the valve only when the readings confirm it’s the cause. Gas work is one area we handle carefully and never suggest a homeowner attempt.
  • Blower motor wear on long-running Carrier models. A blower motor (the fan that pushes heated air through the ducts) that’s worn or a capacitor that’s failed leaves you with heat at the register but no airflow, or airflow that comes and goes. We test amperage draw and replace the motor or capacitor as needed. On many Carrier setups the run capacitor is the cheap culprit, not the motor.
Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Our Carrier Furnace Repair Process

  1. 1
    The call. A live person answers, day or night. We ask what your Carrier is doing (no heat, short cycling, a code on the board) and book a firm arrival window. A failed furnace in a Henderson cold snap is a health risk, so speed matters.
  2. 2
    Diagnostics. The technician checks ignition, gas pressure, flame sensing, airflow, and the control board, reading the fault codes Carrier’s boards store. We don’t guess; we confirm the cause.
  3. 3
    The parts decision. We tell you whether an OEM (Carrier factory) part or a quality aftermarket equivalent is the better call for your model and wallet, and we explain the trade-off. We won’t put a cheap aftermarket igniter in a Carrier unit that eats igniters.
  4. 4
    The written price. Before a single tool comes out, you get the price on paper. It doesn’t change at the door.
  5. 5
    The repair and test. We make the fix, then run the Carrier through full heat cycles to confirm it holds under real load.
  6. 6
    The guarantee and the cleanup. We leave the job site cleaner than we found it and hand you the paperwork.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

What Carrier Furnace Repair Costs in Henderson

Carrier furnace repair in Henderson typically runs $150 – $700, and we give you the exact number before work begins. Here’s how the common jobs break down:

Job Typical range
Igniter replacement $150 – $280
Flame sensor clean or replace $150 – $250
Furnace tune-up $80 – $200
Gas valve repair $280 – $550
Blower motor repair $300 – $700
Heat exchanger repair Quoted after inspection

What moves the price: which part fails, OEM versus aftermarket, and whether your Carrier model needs the control board out to reach it. We give free estimates, so call (844) 797-5122 for an exact quote.

Why Henderson Homeowners Call Coldharbour Heating & Air Henderson for Carrier Work

We put it in writing. Every repair comes with our 365-Day Done Right Promise: if the repair fails within a full year, we come back and correct it at no charge. The guarantee is written down before the technician leaves. You get a firm arrival window up front, a written price before any work starts, and background-checked, uniformed technicians on every visit, so you know exactly who’s walking through your door.

We work to The Kingswell Way: say the price before the work, show up in the window given, leave the place cleaner than we found it, put the guarantee in writing, and come back if it fails. Our technicians are trained on nine major brands including Carrier, Trane, and Lennox, so whatever heats your Henderson home, the person who shows up can work on it. Coldharbour Heating & Air Henderson is independently owned and operated.

FAQs

Need HVAC help nationwide? Licensed & insured · within the hour response · free estimates
Call (844) 797-5122
Local Service Coverage

Request a Free Estimate in Henderson

Tell us what you need - Coldharbour Heating & Air Henderson responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch