Ductless mini splits
AC repair
Furnace & heating
Heat pumps
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Mini-Split Installation: The Henderson Owner’s Guide
Lennox ductless mini-split installation in Henderson typically runs $3,500 – $7,500 installed for a single-zone system, and multi-zone setups sit above that range. We schedule installations rather than promise same-day, because every Lennox mini-split has to be load-calculated for your room, ordered to the right model and voltage, and set for a firm install date with the written price in your hands before we start. Most Henderson owners start looking at this page after a failed part pushes them toward replacement instead of another repair.
You’ll know the moment is close when a system is 10 to 15 years old, when repairs start stacking up season after season, or when a technician tells you a compressor or coil repair costs more than a meaningful share of a new unit. That’s the point where installing a fresh Lennox system usually makes better financial sense than chasing parts.
Which Lennox Models This Applies To
Lennox mini-split systems fall into a few families, and the naming matters when you’re matching an install or a part. The MS8 and MS9 single-zone wall units are the common residential lines, and multi-zone versions use the same outdoor platform across several indoor heads. The key compatibility gotcha: Lennox indoor heads must pair with the matching outdoor unit from the same series, and the refrigerant type matters. Older systems use R-410A; newer ones use R-32 or R-454B. A mismatched pairing is where DIY installs and cheap parts go wrong in Henderson.
To identify your unit, read the data plate on the side of the outdoor condenser, which lists the model number, serial number, refrigerant type, and voltage. Then check the indoor head’s label behind the front cover. Measure nothing on your own if you’re unsure – matching the model and refrigerant is what keeps the warranty valid.
On the OEM-versus-aftermarket question: for a full mini-split installation, sticking with genuine Lennox parts and matching series is the right call. Aftermarket compressors and boards exist, but the small dollar savings usually aren’t worth the risk of a mismatch in an installation that has to last a decade in Henderson heat.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Signs Your Lennox Mini-Split Installation Is Failing
Owners rarely get a clean warning. Here’s what typically shows up first:
- Warm air from the indoor head. Usually low refrigerant charge, a failing compressor, or a blocked metering device. If it cools for a few minutes and then blows warm, the system is short-cycling on a fault.
- Ice on the outdoor coil or refrigerant lines. A refrigerant leak or restricted airflow. Don’t just thaw it and move on; the underlying leak stays.
- Loud clicking or a tripped breaker. A failing capacitor, contactor, or compressor pulling too many amps. On Henderson summers, capacitors fail more often and faster than most parts.
- Water dripping from the indoor head. A clogged condensate drain line, which is common in dry desert air where dust and debris collect fast.
- The system won’t turn on at all. Often a control board fault, a blown fuse, or a bad low-voltage connection. This is the moment most owners start asking about a full installation.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Henderson, a single-zone Lennox mini-split installation typically runs $3,500 – $7,500 installed. The range is driven by the size (BTU capacity) of the head, single-zone versus multi-zone, whether new line runs have to be pulled through an attic or wall, and whether the electrical panel already has a dedicated circuit.
If you’re repairing rather than installing, our AC repair range for Henderson is $150 – $650, and that gives you a useful comparison point. When the repair quote climbs past around $1,200 on a system that’s already 12+ years old, replacement usually wins.
Every installation comes with a written price before any work begins, a firm arrival window, and our 365-Day Done Right Promise: if the install fails in any way within a full year, we come back and correct it at no charge. That’s on paper, not verbal.
DIY or Call Us?
You can safely do a few things: read the data plate, clear dust from the indoor filter, check the breaker, and note when the system fails. That’s it. What you shouldn’t do yourself: open the refrigerant system, handle electrical connections on the outdoor condenser (240V is a real shock hazard), or try to recharge refrigerant. Those are the parts of the job that start fires and void warranties.
Anyone can buy a piece of a mini-split online; installing it correctly takes vacuuming the line set, weighing in the charge, and matching the indoor head to the outdoor unit. If you’re at the point where the system won’t cool and the breaker trips, call us today at (844) 797-5122 for a free estimate. We’re trained on Lennox, Carrier, Trane, and six other major brands, so we can work on what’s already in your home.
FAQs
Most Lennox mini-splits last 12 to 18 years with regular maintenance. Henderson’s dry heat and dust shorten that a bit compared to coastal climates; keeping the indoor filter clean and the outdoor coil clear is the single biggest thing you can do to reach the top of that range.
Yes, often. If the failure is a capacitor, control board, contactor, or drain line, we repair it for $150 – $650 in Henderson. If the compressor or evaporator coil has failed on a system over 12 years old, replacement is usually the better value.
A single-zone install is typically a half-day to a full day depending on line routing and panel work. Multi-zone systems with two to four indoor heads usually take two days. We schedule a firm install date when we write up the price.
We order genuine Lennox equipment and parts matched to your specific model, refrigerant type, and voltage. Because we don’t stock parts in a truck or warehouse, the order is placed once we’ve confirmed the model on your data plate, which is exactly how the part arrives correct the first time.
If your Lennox mini-split is failing and you’re debating repair versus installation, call Coldharbour Heating & Air Henderson at (844) 797-5122 for a free estimate. We answer the phone with a live person 24 hours a day, every day, and every job backs the written price, arrival window, and 365-Day Done Right Promise.
Written by the team at Coldharbour Heating & Air Henderson, serving Henderson and nearby areas.