Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateStyles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
See the difference
Before
After
Before
After
Before
AfterCentral Air Conditioner Installation Cost in Henderson, NV: What $5,500-$12,000 Actually Buys
Most central air conditioner installation in Henderson runs $5,500-$12,000 for a standard split system, all-in: equipment, labor, refrigerant, permit coordination, and haul-away. Call (844) 797-5122 and we’ll give you a written price before any work starts. But here’s the part that decides which end of that range you land on, and whether the new unit actually keeps up in July: the load calculation. Not the tonnage printed on the old unit. Not a guess. A real Manual J load.
Most Henderson homeowners get quoted a replacement based on whatever tonnage their 1998 system was. That’s how you end up with a brand-new air conditioner that still can’t hold 78°F on a 112°F afternoon, because the original installer guessed too, and the guess got copied forward for twenty-five years. We calculate the load first, then price the system that fits it.
Why Henderson’s Climate Makes Sizing the Whole Ballgame
Henderson sits in the hot, dusty Mojave downwind of the Las Vegas Valley. Summer highs run past 110°F most years, and the equipment runs nearly nonstop from May through September. Condensers operate at the edge of their rated capacity here in a way they never do in milder markets, and dust and monsoon wind events load up coils and filters faster than homeowners expect. Sizing is not a nicety in this climate. It’s the difference between a system that keeps the house comfortable and one that runs all day and never quite gets there.
The housing stock adds a wrinkle. Much of Henderson was built during the 1990s and 2000s boom, so a large share of the systems out there are now fifteen to twenty-five years old and hitting end-of-life in brutal cooling conditions. These are stucco-clad tract homes on slab with tile roofs and attic-mounted air handlers, and newer master-planned communities like Green Valley and Anthem with two-story layouts and zoned systems. In a July attic, those air handlers and duct runs see temperatures well past 140°F. Duct leakage and undersized returns that would be a minor annoyance elsewhere become major capacity and comfort failures here.
What a Manual J load calculation actually is
Manual J is the industry-standard method for figuring out how much cooling a specific house needs. A technician measures every room’s square footage, window count and orientation, insulation levels, duct condition, and air infiltration, then runs the numbers through software that accounts for Henderson’s design temperatures. The output is a tonnage and airflow target based on your actual house, not a rule of thumb. Half a ton undersized in a stucco tract home with a superheated attic means the system runs all day and never catches up. Half a ton oversized means short-cycling: the unit blasts cold, shuts off before it dehumidifies properly, and wears out faster. Even in a desert, short-cycling leaves rooms feeling clammy and uneven.
What to Look for in a Henderson Installation Quote
When you compare bids, compare what’s actually in them, not just the bottom line. Here’s what separates a real quote from a low number that grows later:
- A load calculation on paper. Ask to see the Manual J output. A quote that just matches your old tonnage without measuring the house is a guess.
- Duct condition called out. If the quote is identical with and without duct work, someone didn’t look in the attic.
- Permit line item. AC replacements require a permit in Henderson and Clark County. A pulled permit protects your resale value and confirms the work was inspected. If it’s missing from the quote, ask why.
- Electrical panel check. Older Henderson panels sometimes can’t carry the new condenser’s circuit without an upgrade or a different efficiency tier.
- A written price with no add-on line items. Labor, refrigerant, permit coordination, and cleanup all inside the number, not tacked on at the end.
Our written price covers exactly that, handed to you before any work starts, with no changes at the door. That’s The Kingswell Way in practice: say the price before the work, show up in the window given, leave the place cleaner than we found it, put the guarantee in writing, and come back if it fails.
What Drives Your Price Up or Down in Henderson
Between $5,500 and $12,000, four variables move the number most: tonnage, efficiency tier, attic ductwork condition, and electrical panel capacity. Here’s how they land.
| Line item | Typical range |
|---|---|
| Standard split system install (2-3 ton, single stage, standard efficiency) | $5,500-$7,500 |
| Higher-efficiency or two-stage system (better SEER2, quieter, often a rebate target) | $7,500-$10,000 |
| Duct sealing in a superheated attic (common in 1990s Henderson tract homes) | $600-$1,800 |
| Partial duct replacement (crushed or disconnected runs) | $1,200-$3,000 |
| Electrical panel upgrade to carry the new condenser circuit | $1,500-$3,000 |
| Zoned system change-out (Green Valley two-story layouts) | $9,000-$12,000 |
Those duct and electrical numbers aren’t upselling. In a Henderson attic running past 140°F in July, leaking ducts dump cool air into the hot space before it ever reaches a room. A new condenser bolted onto bad ductwork is the most expensive mistake we see: the equipment is fine, the delivery system isn’t, and the house stays hot. Sealing or replacing the runs is what makes the new system actually work. For a repair on the existing system instead of replacement, our AC Repair & Installation in Henderson page covers those calls.
What brands do you install?
Our technicians are trained on nine major residential HVAC brands, including Carrier, Trane, Lennox, Goodman, Rheem, York, American Standard, Bryant, and Daikin, so whatever system is already in the home is one we can work with. If you’re choosing equipment, we’ll walk you through the efficiency tiers available for the tonnage your load calculation calls for, then quote the options in writing.
Do you pull the permit for me?
Yes, and our quote includes permit coordination. Henderson and Clark County require a permit for AC replacement, and you should ask for it from any installer. An inspected installation protects your resale value and confirms the work was done to code, and it’s cheaper than correcting an unpermitted install later.
How the Installation Day Works
- Load calculation and site check. We measure the house, inspect attic ducts, and confirm electrical capacity before quoting a system size.
- Written price before any work begins. You get the number, including labor, refrigerant, permit coordination, and cleanup, before the first tool comes out.
- Permit pulled and coordinated. We handle the application and schedule the inspection so you don’t chase paperwork.
- Removal and new install. The old condenser and coil come out, the new system goes in, and the attic gets sealed and buttoned back up.
- Commissioning and walkthrough. Refrigerant charge verified, airflow confirmed, and we leave the site cleaner than we found it.
- Written guarantee issued. Every job is covered by the 365-Day Done Right Promise. If the work fails within a full year, we come back and make it right at no charge. If it’s a repair rather than an install, that same written guarantee applies, valid for the full year.
FAQs
Most installs run $5,500-$12,000, with the spread driven by tonnage, efficiency tier, attic ductwork, and electrical panel capacity. A straightforward 2-3 ton single-stage swap in good ductwork sits near the low end; a zoned, higher-efficiency system with duct replacement lands near the top. Call (844) 797-5122 for a written price on your actual house, free of charge.
Yes, and it happens constantly when a quote simply matches the old unit’s tonnage. In a 1,800-square-foot Henderson tract home, the right size depends on your windows, insulation, duct condition, and orientation, not the number on the sticker. We run a Manual J load calculation first so the new system fits the house you have. Call (844) 797-5122 and we’ll calculate it before we quote it.
It depends on age and repair cost. A system that’s fifteen to twenty-five years old and needing a major repair is usually better replaced, since equipment in this climate is already at end-of-life. A repair in the $150-$650 range on a newer system is a different call. We’ll give you the written numbers for both paths and let you decide. Call (844) 797-5122.
Yes, Henderson and Clark County require a permit for AC replacement, and it’s part of our written quote. A pulled permit means the work gets inspected, which protects your resale value and confirms it was done to code. Call (844) 797-5122 and we’ll handle the coordination.
Get a Written Price Before You Decide
Start with the load, not the old tonnage. Coldharbour Heating & Air Henderson measures your house, calculates what it actually needs, and hands you a written price before any work begins. Every job is covered for 365 days in writing. Call (844) 797-5122 for a free estimate. Back to home.
Written by the team at Coldharbour Heating & Air Henderson, serving Henderson, NV.
What Our Customers Say
"AC quit on the hottest day of the year of course. Coldharbour had a tech out that evening, found a bad capacitor, and had us cool again within the hour. Charged the quote, not a penny more."
- Doug Feeney"New AC and furnace. They gave me a written quote with a couple of options and no pressure. Showed up on the day they promised and the new system is so much quieter."
- Gloria Dunn"Signed up for a tune up before summer. He found a part starting to fail and showed me the reading, didn't just tell me to trust him. Fixed it then so we wouldn't get stuck in July."
- Sophia Tran